Advertisement
Reset to factory settings
If your extender or hotspot stops working or becomes unpaired, you can reset both to their
factory settings:
1 Make sure the extender or the hotspot is plugged in and the power socket's switched on.
2 Press the Link button on the extender for more than 15 seconds or
the Reset button on the hotspot for 1 second to restore factory default settings. Give it
a couple of minutes. If everything's okay, the Power indicator on both will light up.
È
How to add more Powerline extenders to your existing network
You can expand your home network by adding more extenders to your existing kit.
1 Plug your additional broadband extender directly into a wall power socket.
Make sure the socket's switched on.
2 Press the Link button on your additional broadband extender for 5 to 8 seconds.
Wait for the Power light to go back to steady green.
3 Press the Link button again, this time for 1 second.
4 Within 2 minutes, press the Link button on one of the broadband extenders already in
your home for 1 second to complete the connection to the network.
5 Wait for connection to complete. If everything's okay, the Power and Data indicators on
the new extender will light up.
TIP: you might find it easier to plug your new broadband extender in the same
double power socket or near one of your existing ones whilst you set things up.
To connect using the ethernet cable
1 Connect your device to one of the ethernet ports on the hotspot.
You'll need an ethernet cable for each device you want to connect to the hotspot.
Advertisement
