Setup; Sensor Setup - AcuRite 01135 Instruction Manual

SETUP

Sensor Setup

1
Set the A-B-C Switch
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However, you
must select different letter choices
for each of the sensors if you are
synchronizing more than one.
2
Install or Replace Batteries
AcuRite recommends high quality
alkaline or lithium batteries for
the best product performance.
Heavy duty or rechargeable
batteries are not recommended.
The sensor requires lithium
batteries in low temperature
conditions. Cold temperatures
can cause alkaline batteries
to function improperly. Use
lithium batteries in the sensor for
temperatures below -4ºF / -20ºC.
2
Install Batteries
2 AA batteries
1. Slide off the battery compartment
cover. Take note of the A-B-C
switch setting inside the battery
compartment.
2. Insert 2 x AA batteries into the
battery compartment, as shown.
Follow the polarity (+/-) diagram
in the battery compartment.
3. Replace the battery cover.
4. Repeat steps 1-3 to setup
additional sensors (if applicable;
sold separately).
NOTE: The A-B-C switch positions
must differ between each sensor.
Verify that each sensor has a
different channel selected by
checking the switch position in the
battery compartment.
1
A-B-C Switch
A B C
4