Cadac SKOTTEL BRAAI 50 User Instructions page 6

4. Assembly Instructions
• Note: The hose and regulator are not supplied. For details contact your local stockist.
L
J
Appliance categories: I 3B/P (30), I 3+ (28-30/37) and I 3B/P (37), (DK,
FI, NO, NL, SE, AT, DE, BE, ES, FR, IE, IT, PT, GB, CH)
• On the other end, attach a suitable 30mbar low-pressure
(I3B/P (30) : 30mbar Butane/Propane configurations regulator; I3+(28-
30/37): 30mbar Butane regulator or 37mbar Propane regulator);
I3B/P(37): 37mbar Butane/Propane configurations regulators). Again
making sure that the hose is well seated. The type of hose used shall
comply with the relevant EN standard and locate requirement. In South
Africa the regulator used must comply with SABS 1237.
Appliance category: I 3B/P (50) (AT, DE)
• Screw a Hose with the correct threaded fittings on each end, onto the left
hand ¼" BSP thread of the Valve (O) (Fig.4). Attach a suitable 50mbar
low-pressure regulator on the other end of the hose. The hose used must
comply with DIN 4815 part 2 or equivalent.
• The hose length should be no less than 800mm and shall not exceed
1.5m. Check the expiry date on the hose and replace when necessary or
when national conditions require it.
• Do not twist or pinch hose. Do not route the hose in any manner that will
cause it to come into contact with any surfaces that would become hot
during use.
• Before fitting your gas cylinder (Section 5), ensure that the Valve (M) is
in the OFF position by turning the Control Knob (K) clockwise to its stop
position. (See Fig.8 a, b)
• Fit the Burner Pan(F) onto the Stem(H), and ensure is sealed properly.
(Fig 5)
503-0399 LEV14 (8309T-13) Skottel,Grill2Braai,Paella - User Manual (EU&NZ).indd 4
H
O
Jet
M
Valve
P
Valve Tailpiece
4 4
EN
Fig. 3
O
M
P
Fig. 4
F
H
Fig. 5
2021/09/01 11:04:36