Cleaning Your Cells; Replacing Your Postfilter; Washing Cells In A Container - Honeywell F300A1620 Installation Manual

Cleaning your Cells

• A quick cleaning of the cells can be done by simply wiping down the ionizer wires with a damp cloth. This
will help boost the efficiency of the air cleaner between full cleaning cycles. This quick clean can be done
every time the prefilters are cleaned.
• A full cleaning of the cells will return the air cleaner to its peak efficiency. An easy way to wash the cells is in
a tub of hot, soapy water. Just soak the cells until the water cools, agitate and rinse. For details see below
instructions on Cleaning in a Container, Automatic Dishwasher or Washing Cells at the Car Wash.
• A full cleaning of the cells can be put off for yearly maintenance because the efficiency of the air cleaner
remains high even as it loads up with dirt. A quick cleaning can be done more often. Those wishing to
renew to peak effeciency or with heavier use may want to wash more frequently.
• Resideo recommends using an automatic dishwasher detergent to protect the aluminum of the cells. It is
not recommended to use all purpose cleaners or coil cleaners; these cleaners can degrade the aluminum
in the cells over time.

Replacing your Postfilter

1. The postfilter is an optional filter that boosts the efficiency of the air cleaner. Do not wash the postfilter
because that will neutralize the factory applied charge.
2. The postfilter should be replaced every six months to ensure peak performance.

Washing Cells in a Container

CAUTION
Hazardous Chemical.
Can cause personal injury.
Do not splash detergent solution in eyes. Wear rubber gloves to avoid prolonged detergent contact with
skin. Keep detergent and solution out of reach of children.
NOTE: Always wash the cells first, then the prefilters, to keep
heavy prefilter lint from getting caught in the cells.
1. Use a large enough container, such as a laundry tub or
trash container, to hold one or both cells.
NOTE: Sharp corners on cells can scratch surface of bathtub.
2. Dissolve about 3/4 cup of automatic dishwasher
detergent per cell in enough hot water to cover the cells.
If detergent does not dissolve readily, or forms a scum on
the water, try another brand, or use softened water
3. After detergent has completely dissolved, place cells in
the container and let soak for 15 to 20 minutes. Agitate
up and down a few times and remove.
4. Next, wash the prefilters the same way. Empty and rinse
the wash container.
F300 Electronic Air Cleaner 68-0240EFS—01
WEAR GLOVES TO
PROTECT HANDS
FROM DETERGENT
SOLUTION.
M922A
19