Table of Contents
Advertisement
XVI Technical specifications
Type
System of the broadcasting signal
System of the video signal
Number of Stored programs
Scope of the channel
Signal Intensity
Audio
Speaker output Audio input (speaker)
PC/DTV RGB input
Max. visual angle
14
Resolution
Power supply
Energy consumption
Dimensions of the whole set
Size of the screen
Width Height ratio of the screen
Weight
Ambient temperature
Ambient humidity
Ambient air pressure
Note: The specifications is subject to modification without notice .
XVII Troubleshooting
If there is any abnormal situation during the operation, please make the corresponding check according to the
following instruction before sending for repair.
No video signal
Video and sound
interference
No image and sound
Image is normal, but
there is no sound
The image has no color
The remote controller does
not work
Others
Note:Do not remove the back cover.
PLA-4200M
NTSC-M
PAL/NTSC/SECAM
125
AIR CH2-CH69 ,CABLE CATV1-CATV125
>=70dB
Input impedance >10K .input voltage 0.1-0.5Vrms
2X5W
PC
YP P
B R
Horizontal angle <=150
852X480
AC 100V-240V
350W(MAX)
(W
idth/Height/Depth)46.1X29.1X15.2inch
42 inch
16:9
110 pound
0~35
20%-70%RH
86~106Kpa
Check the connection of the power cord.
Check if the power switch is On .
Check if the unit is under standby status.
Check if the signal source is normally output under the current play status.
Switch off the main power and switch on after 2 minutes.
Check the direction, location and connection of the antenna.
Check if the signal is interfered under the current play status .
Check if there is any interference by the electric apparatus nearby .
Check if the power of the unit and the signal source is stable .
Check if the grounding of the signal cable is good .
Check if any of the building in the environment reflects the radio wave.
Check if the power cable is connected .
Check if the main power is ON.
Check if the signal source has normal output under the current play status.
Check the brightness and contrast of the image and check if the volume setting is correct.
If it is under standby status.
Check if the sound has been input correctly.
Check the volume setting.
Check the MUTE setting.
Check the color setting.
Check if the signal source has been output normally under the current play status.
Check the contact and pole of the remote controller and the batteries, or change the battery.
Clean the transmission window of the remote controller and the receiving window of this unit.
Check if there is any obstacle between the transmission window of the remote controller and the Remote sensor of this unit.
Although the image and sound are normal, there will be noises sometimes with the change of
the operation environment and the expansion of the shell. It is normal .
HDTV(the supporting format is in the attached table)
Vertical angle <=30
(50
Hz
/60Hz)
3W(Standby)
(Power indictor is red)
14
Advertisement
Table of Contents
