Table of Contents
Advertisement
VI Basic operation
Note: The function of the button on the front panel is accord with that on the remote controller.
1.POWER button.
Insert one end of the AC power cord into the AC power socket of the unit.
Insert the power plug of the AC power cord into a suitable AC outlet.
Press the main power switch on the unit. The red Power Indicator will light as the unit enters standby status.
Press the red POWER button on the remote controller and the unit will turn on. The green Power Indicator
will light and an image will appear on the screen.
To turn the unit off, press the red POWER button on the remote and the unit will return to standby status.
The Power Indicator on the front panel of the unit will change from green to red.
Press the Main Power switch on the unit to power it down completely.
7
Note: Do not switch off the unit while the OSD is on the screen.
The PLA-4200M is a digital device. If there is abnormal behavior, press the Main Power Switch on
the front panel to switch the unit off. Wait 2 minutes and switch the power back on. If the set still
does not work normally, contact the manufacturer.
2. Set the video input source
Select the source by pressing the TV/VIDEO button until the desired source appears.
3. How to setup TV reception
1 Auto channel
Press the TV/VIDEO button on the remote controller
to select the TV status.
Press MENU button.
Press CH+ or CH- button to open the TV SETUP
menu (a).
Press MENU button to enter the Setup mode and press
CH+ or CH- to select the MODE item.
Press VOL+ or VOL- to select Cable or Air
Press CH+ or CH- to select AUTO CHANNEL. Press
the MENU button to begin the automatic search and
store..
2 FINE TUNE
If the image receiving is poor, press CH+ or CH- to select FINE TUNE item in menu (a). Press VOL+ or VOL-
to adjust the picture quality.
3 Select the TV channel
Press the CH+ or CH- button on the remote controller to switch to the previous and next channel of the current
program.
Press the 0-9 digit button and 100 button on the remote controller to select either AIR for channels CH2-CH69
or CABLE for channels CATV1-CATV125
To channels in each mode:
Air channels CH2-CH9: press the appropriate 2-9 digit button directly.
Air channels CH10-CH69: press 2 digit buttons in sequence.
Cable channels CATV1-CATV9: press the appropriate 1-9 digit button directly
Cable channels CATV10-CATV99: press 2 digit buttons in sequence.
Cable channels CATV100-CATV125: press the 100 button first, then press the necessary digit buttons in sequence.
4 CH ADD/ERASE is used to add and erase channels which were programmed with AUTO CHANNEL.
Select the channel to erase by pressing the 0-9 and 100 buttons or the CH+ and CH- buttons on the remote controller.
With the channel selected, press the CH ADD/ERASE button to erase the channel. The Channel No. changes from
yellow to blue when it is erased.
To restore an erased channel, select the blue Channel No. and press the CH ADD/ERASE button.
Note: Please keep at least two stored channels.(The Channel Number is blue.)
Cable Mode has three modes:CABLE-STD,CABLE-HRC and CABLE-IRC.Please choose the suitable
mode depending on your local situation.
Analog RGB
YPbPr
TV SETUP
SET
MODE
AUTO CHANNEL
FINE TUNE
UP
DOWN
EXIT
Air
Press SET
50
7
Advertisement
Table of Contents
