Program Selection - Beko DFN 1001 X Instruction Manual

and program cancellation will not be
possible.
Starting Your Machine
•
Open the tap.
•
Plug the mains plug into the wall
socket.
•
Open the door.
•
Press On/Off button.
•
Check if the salt and rinse aid
indicators light and add salt and/or
rinse aid if needed.
•
Place the dishes.
•
Check if the upper and lower
impellers rotate freely.
•
Put sufficient amount of detergent
in the detergent dispenser and
close its lid.
•
Start the program by pressing
Start/Pause/Cancel button.
WARNING:
Pay attention not to open the door of
the machine when it is running. Stop
the machine by pressing Start/Pause/
Cancel button if you have to open the
door. Then, open the door. There may
be a rush of vapor when you open
the door of your machine. Be careful.
Close the door and press Start/Pause/
Cancel button again. Program will
resume running.
•
Key lock will be activated 30
seconds after the program starts
and "Key Lock Activated" will be
displayed.
•
Energy saving system will be
activated 90 seconds after the
program starts and the display is
dimmed. If you touch the button
again, display brightness returns
to its original status.
•
"End" will be displayed when the
program is over. The amount of
water and energy consumed will
be displayed consecutively.
•
Press the On/Off button to turn off
your machine when the program
is over.
•
Close the tap.
•
Unplug the mains plug from the
wall socket.
•
Leave your dishes in the machine
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.

Program selection

You will be prompted to select ECO
or AUTO program when you press
"Start / Pause / Cancel" button while
the "Press to wash" message is being
displayed.
When you see the "Press to wash"
message, press "Start / Pause /
Cancel" button. Messages that
countdown for AUTO program will be
displayed:
Press for AUTO 5
Press for AUTO 4
Press for AUTO 3
Press for AUTO 2
Press for AUTO 1
If no process is done at the end of the
countdown, "ECO program selected"
message will appear and washing will
start.
If you want your machine to wash in
AUTO program, press "Start / Pause
/ Cancel" button during countdown.
"Press to wash" message is displayed.
When you press the "Start / Pause /
Cancel" button again "AUTO program
30 EN