Toro TimeCutter SS 5060 Operator's Manual page 20

Pushing the Machine
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place (Figure 24).
Note: Ensure this is done for each lever.
5. Move the motion-control levers inward to the neutral
position and turn the ignition key to the Run position.
Note: Do not start the machine.
Note: You can now push the machine by hand.
Figure 24
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, ensure that the key returns to the Stop
position to avoid draining the battery charge.
Note: If the machine fails to move, the electric brake may
still be engaged. If necessary, the electric brake can release
manually; refer to Releasing the Electric Brake (page 31).
Operating the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in Figure 24.
Note: Ensure this is done for each lever.
3
1 2
g017303
3. Lever position for pushing
the machine
20