Getting Started; Battery Removal And Installation; Important Battery Information - VTech Style & Glam On Unicorn 5425 Instruction Manual

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the side of
the unit, use a screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling up on one end
of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following
the diagram inside the battery box. (For
best performance, alkaline batteries or fully
charged Ni- MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
4