Patton PUH9000 - Power Utility Heater Manual

TECHNICAL SPECIFICATIONS

• Wattage: 1500W (+5% –15%)
• Working voltage: 120V AC/60Hz

AUTO SAFETY SHUT-OFF WITH INSTANT

TIP-OVER PROTECTION
This heater is equipped with a Total Safety System with tip-over protection that will shut-off the heater in an overheat situation.

TIP-OVER SHUT-OFF:
When the unit is accidentally knocked over, it will shut off. To reset, simply place the heater in an upright position on a level surface.

OVERHEAT SHUT-OFF:
When a potential overheat temperature is reached, the system will automatically shut the heater off and the caution light will illuminate. Make sure heater is clear of all obstructions.

RESET INSTRUCTIONS

If the unit shuts down:

1. Turn MODE to OFF ( ) and THERMOSTAT to HI ( ).
2. Unplug unit, wait 10 minutes.
3. Plug in and turn ON.

PRE-OPERATING INSTRUCTIONS

1. Carefully remove your heater from the box. (please save the carton for off-season storage).
2. Make sure the unit is in the OFF position before plugging the heater into the outlet.
3. Place heater on firm level surface.
4. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps.

NOTE: THIS UNIT IS FOR FLOOR USE ONLY

OPERATING INSTRUCTIONS

1. For heater operation, please set the Temperature all the way to HI ( ).
2. Turn the Selector Control to desired heat setting (LO (I) for 750W or HI (II) for 1500W).
3. The Power Light will remain lit during operation.

SETTING THE TEMPERATURE

1. You need to set temperature on HI ( ) to start heater. Allow heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached, lower the temperature setting until the heater stops operating.
3. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF.

NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the temperature setting.

CLEANING/MAINTENANCE

DURING SEASON CARE

1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild soap solution.
3. NEVER use abrasive or flammable solvents to clean the unit.
4. After cleaning, be sure to completely dry the unit with a cloth or towel.

AFTER SEASON CARE

1. Store heater in a cool, dry location
2. The manufacturer recommends that you store the unit in its original carton.

TROUBLESHOOTING

If your heater fails to operate:

• UNPLUG THE UNIT.
• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions.
• The temperature may be set too low. Turn the temperature knob clockwise until the heater restarts.
• Make sure selector is in LO (I) or HI (II) setting.

Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions or call consumer service at 1-800-546-5637.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Patton PUH9000 - Power Utility Heater Manual