Patton PRH8 - Heater Manual

Table of Contents

Contents

1 FEATURES & OPERATIONS
- 1.1 OVERVIEW
- 1.2 TECHNICAL SPECIFICATIONS
2 OPERATING INSTRUCTIONS
3 CLEANING/MAINTENANCE
- 3.1 AUTO SAFETY SHUT-OFF WITH TIPOVER PROTECTION
4 TROUBLESHOOTING
5 Documents / Resources
- 5.1 References
- 5.2 Download manual

FEATURES & OPERATIONS

OVERVIEW

THERMOSTAT CONTROL (with "O" OFF setting)
POWER SWITCH (HI/LO)
CARRY HANDLE (rear of unit)
AUDIBLE SAFETY ALERT

TECHNICAL SPECIFICATIONS

Amps: 12.5
Wattage: 1500W (+5% -10%)
Working voltage: 120V AC/60Hz

OPERATING INSTRUCTIONS

Place heater on firm level surface.
Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps.

Mode Settings

To start the heater operation, turn the Thermostat Control clockwise all the way to the highest setting.
Switch the Selector to your desired heat settings:
LO - Low Heat
The heater will run continuously at 750W.
HI - High Heat
The heater will run continuously at 1500W.
The Power Light will remain lit during operation.

Thermostat Control

Turn the Thermostat Control clockwise to the highest position to start heater. Allow heater to operate and warm up the room.
When the desired temperature/comfort level is reached, lower the temperature setting by turning the Thermostat Control counter-clockwise until the heater stops operating.
The thermostat will now automatically maintain the pre-set temperature level by turning the heater ON and OFF.

NOTE:
It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, raise the temperature setting.

CLEANING/MAINTENANCE

Always unplug the heater before cleaning and allow the heater to cool down.

Clean the unit with a soft cloth moistened with a mild soap and water solution.
NEVER use abrasive or flammable solvents to clean the unit.
After cleaning, be sure to completely dry the unit with a cloth or towel.
Store heater in a cool, dry location.
It is recommended that you store the unit in its original carton.

AUTO SAFETY SHUT-OFF WITH TIPOVER PROTECTION

This heater is equipped with a Total Safety System with tip-over protection that will shut-off the heater in an overheat situation.

Tip-Over Shut Off:
When the unit is accidentally knocked over, it will shut off. To reset, simply place the heater in an upright position.

Audible Safety Alert:
This heater includes an audible alarm to warn that parts of the heater are getting excessively hot. If the alarm sounds, immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause high temperatures.
DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING.

Overheat Shut-Off:
When a potential overheat temperature is reached, the system will shut the heater off. Make sure heater is clear of all obstructions. Heater will resume operation when it is clear of obstructions and has had a chance to cool down.

RESET INSTRUCTIONS:
This unit is equipped with an automatic reset feature. If the unit shuts off, wait for it to cool down (30 minutes).
When cool, the unit will automatically restart.

TROUBLESHOOTING

If your heater fails to operate:

UNPLUG THE UNIT and make sure the heater is placed in an upright position
Make sure the electrical outlet or circuit breaker is working.
Check for obstructions. If you find an obstruction turn the heater OFF, and unplug the unit. Carefully remove the obstruction and follow the reset instructions.
The temperature may be set too low. Turn the thermostat knob clockwise until the heater restarts.

Please DO NOT attempt to open or repair the heater.

If you have any questions regarding your product or would like to learn more about other Patton^® products, please contact our Consumer Service Department at 1-800-333-1930 or visit our website at www.pattonproducts.com.