INTRODUCTION Thank you for your purchase of this Third Coast Equipment, Inc. (“Third Coast”) single-direction vibratory plate compactor. Please read this operator’s manual in its entirety prior to using your new machine. This manual provides information pertaining to the safe use, proper operation, and routine maintenance of this machine.
MACHINE LABELS SAFETY LABELING The following hazard, notice, and informational labels are included on this Third Coast machine and must be understood by all operators prior to operating this equipment. HAZARD & NOTICE ICONOGRAPHY Third Coast machines use International Standardization Organization (ISO) compliant LABEL INTERPRETATION iconographic labeling to depict and differentiate this machine’s dangers, warnings, and cautions...
MECHANICAL HAZARDS HAZARDS & RISKS Certain mechanical hazards are inherit in operating this machine due to the weight, operation, travel, and vibration of this machine. Disregarding these warnings can lead to CALIFORNIA PROPOSITION 65 WARNING serious injury. Use of this product may expose you to certain chemicals, including gasoline Do not operate this machine unless all protective guards are in place.
gases from internal combustion engine driven equipment can cause death in confined spaces. OPERA TION Do not refuel this machine in confined spaces. Gasoline vapors may be hazardous to your health, and concentrated gasoline vapors may cause an explosive atmosphere. STEPS BEFORE FIRST USE Any fluids spilled from the machine, whether flammable or not, must be cleaned up in a manner To get you up and running faster, pre-delivery service is completed at Third Coast’s warehouse...
HONDA ENGINE STARTUP USING THE WATER TANK Position the On/Off lever and fuel valve to the ON This single-direction plate compactor features an integrated water tank to distribute water under THROTTLE position, and the throttle lever to the idle position ( the plate compactor.
TIPS FOR PROPER COMPACTION EXTENDED STORAGE Proper compaction is extremely important in construction, as it eliminates extraneous air in the Following proper long-term storage procedures ensures the machine is ready to operate when substrate and reduces the transport of air and water, resulting in a more stable base with less you return to it.
FULL VISUAL INSPECTION CARE & PREVENT A TIVE MAINTENANCE At the start of each workday, or after each eight hours of machine operation, perform a full visual inspection of the machine, looking for signs of visible damage to any component. Repair or Third Coast plate compactors are designed to provide years of trouble-free service, but as with replace any defects found prior to operating the machine.
TABLE 5: COMPACTOR SPECIFICATIONS specification for that class. To identify whether a fastener is a Class 8.8 or Class 12.9 fastener, check the identifying marks stamped on the head. WEIGHT & DIMENSIONS SP3410 SP5013 SP4518 Operating Weight, lb Base Plate Width, in (A) Base Plate Length, in (B) 19.5...
ENGINE SPECIFICATIONS TROUBLESHOOTING This machine is available with Honda GX160 or Vanguard 200 engine options: SYMPTOM POSSIBLE CAUSE SOLUTION TABLE 6: ENGINE SPECIFICATIONS Engine does not start, Ignition switch in Off “O” position (Honda Turn switch to On “I” position. HONDA GX160 VANGUARD 200 but has spark.
WARRANTY specification. Worn or damaged hand pivot Inspect rubber shockmounts on both Third Coast Equipment stands behind all of its products with a best in class shockmounts. inside and outside of handle pivot point warranty, including: for cracking or wear. Replace if needed.
Page 13
3CE Dealer Card Third Coast Equipment, inc. New Berlin, WI SP - OM-01 thirdcoastequipment.com...
Need help?
Do you have a question about the SP3410 and is the answer not in the manual?
Questions and answers