Sealey LH251 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instruction
manual
1. contents
section 2. ......................................................General: page 1.
section 2.1. ............................................ identification: page 1.
section 2.2. ........................................ technical data: page 1.
section 3. ........................................................ safety: page 1.
section 4. ...................................................operation: page 2.
section 5: ............................................................. maintenance
section 6. .............................. inspection/examination: page 2.
2. general
2.1. identification
supplier: sealey Power Products,
Kempson Way,
suffolk Business Park,
Bury st edmunds,
suffolk, iP32 7Ar.
model no: lh251
2.2. technical Data (a, c, D, k and l refer to fig.1)
model no: ....................................................................... lH251
capacity: .........................................................................250kg
test load: ........................................................................375kg
load chain Ø: ...................................................................4mm
Pulling effort to lift full load: ..........................................25kgf
Head room: ..................................................................220mm
chain falls: .............................................................................1
chain length: ................................................................. 1.2mtr
lever length (l): ...........................................................160mm
overall Width (c): ............................................................85mm
overall depth (A): ............................................................92mm
operating clearance: ......................................................60mm
Hook Aperture (K): ...........................................................20mm
maximum Hook capacity Ø (d): ......................................30mm
Weight: ................................................................................2kg
a) design capability: test load 50% overload.
b) for applications - see section 3.
c) for information on parts and materials requiring
specialised repair techniques - see section 4.
d) Ambient operating temperature is between
-10°c and +50°c
3. safety
f
ensure that the lever hoist is in a good working order and condition. follow the inspection requirements as described in section 6.
9
maintenance. take immediate action to repair or replace damaged parts by contacting your supplier. ensure that all accessory
9
lifting devices are suitably certified. if lever hoist is damaged, remove from service immediately.
use recommended parts only. the use of unauthorised parts may be dangerous and will invalidate the warranty.
9
Warning! failure to heed safety and warning instructions may result in damage and/or personal injury and will invalidate the
‰
warranty.
this lever hoist is designed for lifting within a garage or workshop environment.
9
ensure the support for the lever hoist is capable of withstanding a load of at least 1½ times the lever hoist safe working load.
9
Keep the lever hoist clean for the best and safest performance.
9
© Jack sealey limited
instructions for
mini lever hoist 250kg
lh251
model no:
section 7. .................................................. Assembly : page 3.
section 8. ...................................................... storage: page 3.
section 9. ..........................................responsibilities: page 3.
section 10: ..................... declaration of conformity: page 3
fig.1
Original Language Version lH251 | issue: 2 (l) 05/10/17 page:1