Plantronics Encore H101N Quick Start User Manual page 3

16845 Plantronics 11/7/02 10:33 AM
Use these steps to get set up quickly:
H191
1 Standard
Model
Adjustable
Headband
Receiver
I dentify the
Click
Components Stop
Turret
Quick Disconnect
Connector
Headset Cord
5
Examine
the Additional
Features
Clothing Clip
The clothing clip keeps
the headset properly
seated and free from
the cord's weight.
Attach the clothing clip
at a comfortable level.
Quick Disconnect ™
Connector
This feature allows you
to place a call on hold
and move away from
the phone without
removing the headset.
When you separate the
Quick Disconnect, you
place an ongoing
conversation on hold.
Before using your headset,
join the Quick Disconnect to the mating
connector of the modular adapter cable.
To put your call on hold, grasp Quick
Disconnect, as shown, and pull straight
apart. To resume your conversation,
reconnect the halves.
See Maintenance and Troubleshooting section on the other side.
Page 2
ENCORE ®
FAMILY OF HEADSETS
H101
Noise-
Canceling
Model
T- Bar
Ear Cushion
Voice Tube
™
Clothing
Clip
Polaris
To use the Polaris headset
model, simply insert the
modular connector into
the headset receptacle of
a compatible telephone.
Polaris applies to most
headset ready telephones.
4
Adjust the
Tone Controls
For Standard
Models:
4.1 Adjust the tone
by moving the tabs on
the receiver as shown.
To equalize sound, move
the tabs to the same
setting on each receiver.
4.2 To emphasize lower,
or bass tones, move the
receiver tabs to the position
marked " ".
4.3 To emphasize higher,
or treble tones, move the
receiver tabs to the position
marked " ".
2
Tone
Control
Tabs
Noise -Canceling
Microphone
Boom
Models
™
3
Adjust the Mouthpiece
For Standard Models:
3.1 Hold the receiver securely
against your ear with one hand.
With your other hand, adjust the
clickstop turret and the voice tube
so that the tip sits two finger-
widths from the corner of your
mouth. (To prevent breath noise,
avoid putting the voice tube in
front of your mouth.)
For Noise-Canceling Models:
3.2 Carefully bend and shape the
boom with both hands as shown.
Avoid bending or twisting the
boom near the microphone or
4.1
earpiece.
3.3 Position the clickstop turret and
boom so that the microphone is
two finger-widths from the corner
of your mouth.
3.4 Make sure the front of the
microphone faces your mouth. If
necessary, twist the microphone
4.2
slightly so it's in the proper
position. Do not use forceful
twisting motions or try to turn the
microphone completely around.
4.3
Adjust the
Headband
2.1 To adjust the headband,
lengthen or shorten the band
until it fits comfortably. The
clickstop feature keeps the
headband securely adjusted.
Position the headset receivers
so that the foam cushions sit
comfortably over the center of
your ears.
2.2 On models with only one
receiver, position the stabilizer
T-bar above your ear.
Front
2.1
2.2
3.1
2"
50.8 mm
3.2
3.3
Back
3.4