Working Time Configuration (Necessary If 7/42 Channel Transmitters Are Used); Radio Codes Deletion - TELECO AUTOMATION TVPLS868TT3 Instructions Manual

2.2

WORKING TIME CONFIGURATION (NECESSARY IF 7/42 CHANNEL TRANSMITTERS ARE USED)

Attention: the following procedure is necessary when using 7/42 channel transmitters (type C).
P1
*
10x
Press the button P1 10 times and keep it pressed for 3
seconds. The buzzer emits an intermittent sound.
2.3

RADIO CODES DELETION

TYPE OF DELETION
SINGLE RADIO CODE
Press 5 times the button P1 and keep it pressed. The buzzer emits an intermittent sound. Press the button of the transmitter relative to the code to be deleted within 10
seconds. Successful deletion is indicated by a continuous sound of the buzzer.
ALL THE RADIO CODES
Press 6 times the button P1 and keep it pressed for 10 seconds. The buzzer emits a fast intermittent sound. Release when the sound becomes continuous.
* The buzzer will make a beep each press.
(>3 s)
P1
*
5x
*
6x
No more than a second should pass between one press to another one.stopped.
...
intermittent sound
Command a
manoeuvre using
a memorized
transmitter or
by means of the
wired input.
Press P1 again or wait
25 seconds to quit
the procedure without
saving.
keep it
pressed
intermittent
(10 s)
sound
13
complete
complete
closing
opening
...
...
LM flashes
Note: this automatic cycle can be stopped with any
command. If working time is exceeded (90 s), the control
unit stops and emits an intermittent sound until any button
is pressed.
...
Press the button of the transmitter
relative to the code to delete
...
P1
complete
opening
P1
continuous
sound
continuous
sound