Holmes Blizzard HAOF90, HAOF90C, HAOF91 -Oscillating Power Fan Manual

Also See for Blizzard HAOF90:

Owner's manual (4 pages)

Owner's manual (2 pages)

Owner's manual (2 pages)

Table of Contents

Contents

1 ASSEMBLY INSTRUCTIONS
2 OPERATING INSTRUCTIONS
3 WALL MOUNTING INSTRUCTIONS
4 CLEANING/MAINTENANCE INSTRUCTIONS
5 FAN STORAGE
6 Documents / Resources
- 6.1 Download manual

Holmes Blizzard HAOF90, HAOF90C, HAOF91 -Oscillating Power Fan Manual

ASSEMBLY INSTRUCTIONS

Your fan comes fully assembled and ready for use.

Overview

Fan Hub
Front Grill
Base
Wall Mount Lock (not shown) HAOF90
Rear Grill
Speed Control, Oscillation (not shown)

OPERATING INSTRUCTIONS

Set the fan base on a dry, level surface.
Please make sure the On/Speed knob is in the "Off" () position. Plug the cord into any standard 120-volt A/C outlet.
The SPEED is adjusted by moving the knob left or right to the desired setting: OFF-(), LOW-(), MEDIUM-(), HIGH-().
The OSCILLATION control knob is located on top of the fan motor housing. To start oscillation, push control knob down. To stop oscillation, pull control knob up.

WALL MOUNTING INSTRUCTIONS

Your Blizzard^® power fan can be wall mounted and is designed to operate from 4 different positions while wall mounted. The first 3 positions are set by gently pushing the fan head to the desired location. To set the fan in the fourth and furthest back position, press down firmly on the wall mount lock at the back of the fan neck with one hand, while pushing the fan head back into the fourth position with your other hand.

Please Note: When taking the fan down from the wall and changing to table fan operation, make sure to pull the fan head forward out of the fourth wall-position. Pull gently forward until you hear the wall mount lock secure the fan back into table mode. You will then have the 3 standard table fan positions available to choose from.

Step 1: After selecting a suitable location on the wall, use the corresponding mounting location guide below to ensure proper placement.

Step 2: Use the holes below as a guide and mark the correct place where the screws will be inserted. Consult with a Hardware or Home Center for the best screws for your type of wall.

NOTE: Please be sure that you use the correct mounting location guide for your particular fan. The model number can be located on the box or on the rating label which is located on the back of the fan head.

Step 3: Secure the screws almost all the way into the wall using a screwdriver.

Step 4: Line up the holes on the back of the unit with the screws to hang your fan. Make sure the screws are secured into the wall before carefully placing the fan on them.

CLEANING/MAINTENANCE INSTRUCTIONS

Follow these instructions to correctly and safely care for your power fan. Please remember:

Always unplug the fan before cleaning or disassembling.
Be sure to use a soft cloth moistened with a mild soap solution.
Do not allow water to drip on or into the fan motor housing.
Do not use any of the following as a cleaner: gasoline, thinner, benzene.
Use a soft cloth moistened with a soap solution to carefully clean the front and rear grills.
We also recommend the periodic cleaning of this fan by lightly running a vacuum cleaner nozzle over the fan grill to remove any dust or dirt that may have accumulated inside or on the unit.

FAN STORAGE

Your fan can be stored in the off-season in the original (or appropriately sized) box. It is important to keep it in a safe, dry location.

If you have any questions regarding your product or would like to learn more about other Holmes^® products, please contact our Consumer Service Department at 1-800-546-5637 or visit our website at www.holmesproducts.com