Preparing The Generator - Case C12000ES User Manual

Grounding Instructions
Improper connection of the equipment grounding
conductor can result in a risk of electrocution.
Check with a qualified electrician if you are in doubt as to whether the
unit is properly grounded for your local regulations.
The ground terminal on the frame can be used to connect the generator
to a suitable ground source. The ground path should be made with #8 size
wire. Connect the grounding wire securely to the ground terminal. Connect
the other end of the wire securely to a suitable ground source.
A metal underground water pipe in direct contact with the earth for at
least 10 feet can be used as a grounding source. If a pipe is unavailable,
an 8 foot length of pipe or rod may be used as the ground source. The
pipe should be 3/4" diameter or larger and the outer surface must be
noncorrosive. If a steel or iron rod is used it should be at least 5/8"
diameter and if a nonferrous rod is used it should be at least 1/2" diameter
and be listed as material for grounding. Drive the rod or pipe to a depth of
8'. If a rock bottom is encountered less than 4' down, bury the rod or pipe
in a trench. All electrical tools and appliances operated from this generator
must be properly grounded by use of a third wire or be "Double Insulated".
It is recommended to:
1. Use electrical devices with 3 prong power cords.
2. Use an extension cord with a 3 hole receptacle and a 3 prong plug at
the opposite ends to ensure continuity of the ground protection from
the generator to appliance.
We strongly recommend that all applicable regulations relating to
grounding specifications be checked and followed.
14

PREPARING THE GENERATOR

DANGER