Sixnet QUICKONNECT GSM M-1300 Quick Start Manual

UNPACKING INSTRUCTIONS

Unpack the Sixnet Wireless unit and verify the following
1
components are enclosed for the QuicKonnect (Figure A).
Figure A: Package Contents M-1300:
Power Supply
(United States)
Not Shown: Antenna included with model M-1300
* Non-US power supplies require customer-supplied power cord to connect power
to AC power outlet
If any items are missing, please contact Sixnet Wireless
2
at +1 800 489 7781.
Optional item to use for Out-of-Band (OOB) Management
3
function of the Sixnet Wireless modem: Cisco DB9 to RJ45
Console Cable
GSM MODELS M-1300-G
In most situations, the M-1300 will arrive with the SIM card
1
installed. If not, open the case...
Insert the SIM supplied by your carrier into the SIM socket.
2
Be sure the SIM is securely fastened by pushing the metal
slide outward to the lock position.
Note: The notch on the SIM card should be on the bottom right hand side of
the SIM socket.
Open
331 Ushers Road • Ballston Lake, NY 12019 • USA • T +1 518 877 5173 • F +1 518 877 8346 • sales@sixnet.com
Power Supply
(International)
Ethernet Cable
(6' CAT 5E 568B)
Closed
Attach power supply connector to the "barrel" power outlet
3
on the back of the unit and connect power supply plug to an
AC power outlet.
Verify the POWER (green) LED is lit to indicate that the unit
4
is receiving power.
Please allow 2-4 minutes for the unit to connect to the
5
cellular network. When this has occurred the Signal Strength
LEDs should light up from 1 to 4 LEDs. Sixnet Wireless
recommends 2 bars or greater for proper functionality of the
unit. If signal strength is showing 1 LED or showing the top
and bottom LEDs (1 and 4 positions), please refer to the
User Manual at www.sixnet.com.
6 Connect to the Ethernet RJ45 port for network connectivity.
Note: Devices connected to the Ethernet RJ45 port need to be configured with
DHCP client enabled to receive their IP address.

ACCESSSING THE GRAPHICAL USER INTERFACE (GUI)

Connect PC to QuicKonnect™
1
The Ethernet Port on the QuicKonnect™ is "auto-sensing",
which means a straight through or cross-over cable can be
used to connect to the Sixnet router.
Connect a CAT-5 Ethernet cable between the local PC and
the unit's Ethernet port. Verify the link LED is lit.
Setup PC IP Address for DCHP
2
Select "Obtain IP Address automatically".
For assistance with configuring your PC, see the appropriate
Microsoft Windows support webpage listed at:
http://support.microsoft.com.
Access Graphical User Interface
3
Open command prompt type in "ipconfig".
"Default Gateway" and use that as the Address to browse to
on port 10000. If the "Default Gateway" has an IP address of
66.25.123.46, in your browser enter http:// 66.25.123.46:10000
to access the login screen.

LOGIN INSTRUCTIONS

• User Name enter:
admin (lowercase letters)
• For Password enter:
six digit serial number of unit (lowercase)
Upon successfully logging in you will see the following screen
(Figure B on reverse side)
Most wireless carriers will require a userID, password, and
APN to be entered into the unit. See user manual at
www.sixnet.com for additional information.
QUICK START GUIDE
QUICKONNECT™
GSM M-1300
Look at the
www.sixnet.com