Second Zone Speaker B Setup; Switching The Speaker System - Pioneer VSX-816-K Operating Instructions Manual

11 Other connections
3 Press CLASS to select one of the three
classes then press
preset you want.
You can also use the number buttons to select
a preset.
• The default for all presets is XM001.
4 Press ENTER .
After pressing ENTER, the preset class and
number stop blinking and the receiver stores
the XM channel.
Listening to channel presets
You will need to have some presets stored to do
this.
1 Press CLASS to select the class in which
the channel is stored.
Press repeatedly to cycle through classes A, B
and C.
2 Press
you want.
• You can also use the number buttons on
the remote control to recall the channel
preset.
Connect & Play™, XM-Ready
Playlist are trademarks of XM Satellite Radio Inc.
©2005 XM Satellite Radio Inc. All rights reserved.
All other trademarks are the property of their
respective owners.

Second Zone speaker B setup

After selecting Second Zone in Surround back
speaker setting on page 34, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system below for the
listening options with this setup.
Note
1 • The subwoofer output depends on the settings you made in Speaker Setting on page 40. However, if SP B is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the Surround back speaker setting on page 34 output from the surround back pre-out terminals may change.
• All speaker systems (except Second Zone connections) are switched off when headphones are connected.
54
En
to select the channel
to select the channel preset
®
and The Ultimate
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in Connecting the speakers on
page 19. Make sure to review Hints on speaker
placement on page 20 when placing the
speakers in another room.
2 Select ' Second Zone' from the ' Surr Back
System' menu.
See Surround back speaker setting on page 34
to do this.

Switching the speaker system

If you selected Second Zone in Surround back
speaker setting on page 34, three speaker
system settings are possible using the
SPEAKERS button. If you selected Normal (SB)
or Front Bi-Amp, the speaker system is fixed
as SP A or SP AB (respectively). The options
below are for the Second Zone setting only.
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
ANALOG MIDNIGHT/
DIMMER ATT LOUDNESS
TUNING / TUNER
STATION EDIT TONE
Press repeatedly to choose a speaker system
option:
• SP A – Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
• SP B – Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
SPEAKERS
QUICK
SETUP SETUP RETURN
MULTI JOG
1