Table of Contents
Advertisement
Fault
The touchscreen dis-
play is not respond-
ing or has frozen.
The cooking zone's
power level cannot
be increased.
Audible signal
The hob is respond-
ing in an unusual
manner or can no
longer be operated
correctly.
One or all cooking
zones have been
automatically
switched off.
The transfer settings
function cannot be
activated.
The FlexPlus cooking
zone cannot be activ-
ated.
/
The cooking zones
do not heat up, and
is displayed.
26.3 Normal noises from your appliance
An induction hob may sometimes cause noises or vi-
brations, such as buzzing, crackling, hissing noises, fan
noises or rhythmic noises.
27 Disposal
27.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Cause and troubleshooting
The control panel is wet or an object is covering it.
▶
Dry the control panel or remove the object.
The hob's total power output has been limited.
▶
Change the total power under "Maximum power consumption" in the basic settings.
▶
If a very large item of cookware is being used, this may have an effect on the maximum
power level for that half of the hob. Place the cookware back on the hob.
There is something on the touch display.
1.
Remove the object and reconfigure the hob settings.
2.
Do not place hot cookware on the control panel.
A fault has occurred in the electronics.
1.
Switch off the appliance using the mains fuse or the circuit breaker in the fuse box.
2.
Wait a few seconds before reconnecting the appliance.
The electronics have overheated and one or all of the cooking zones have been switched
off.
There is hot cookware in the vicinity of the control panel. The cooking zone has been
switched off to protect the electronics.
The cooking zone has overheated and has been switched off to protect the work surface.
Electronics fault
▶
Touch any button to confirm the fault display. You can continue to cook as normal
without using the flexMotion function. Contact customer service.
Electronics fault
▶
Touch any sensor to confirm the fault display. You can use the remaining cooking zones
to continue cooking. Contact the technical after-sales service.
The hob is unable to connect to your home network or the extractor hood.
1.
Acknowledge the fault display by touching any of the sensor fields. You can cook as
usual without a connection.
2.
If the problem persists, contact our technical after-sales service.
The operating voltage is incorrect and outside of the normal operating range.
▶
Contact your energy supplier.
The hob is not connected correctly.
▶
Disconnect the hob from the mains. Connect the hob in accordance with the circuit dia-
gram.
Demo mode is activated.
1.
Disconnect the hob from the mains and, after a few seconds, reconnect it.
2.
Deactivate demo mode in the basic settings within the next three minutes.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Disposal en
23
Advertisement
Table of Contents
