Trouble Shooting - VALERII S&M GROUP 0503LGS5202 Instruction Manual

fine-toothed file and smooth any burrs or crushed area along the cutting edge.

TROUBLE SHOOTING

PROBLEM
Motor Stops to
Start
Fails to split logs
The log pusher
moves jerkily,
taking unfamiliar
noise or vibrating a
lot
Oil leaks around
cylinder ram or
from other points.
PROBABLE CAUSE
Overload Protection
disengaged to protect the log splitter
from being damaged
Log is improperly positioned
The sizes or hardness of the log
exceeds the capacity of the machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment
made on Max. Pressure Limiting
Screw. Lower max pressure rating
was set.
Lack of hydraulic oil and excessive
air in the hydraulic system.
Air sealed in hydraulic system while
operating.
Bleed Screw is not tightened before
moving the log splitter.
Oil Drain Bolt with Dipstick is not
tight.
Hydraulic Control Valve Assembly
and / or seal(s) worn
REMEDY SUGGESTED
Device Contact a qualified Electrician for opening
the Pushbutton Box to engage the Overload
Protection Device inside *
Refer to " Log Splitter Operation" section for
perfect log loading.
Reduce the log sizes before splitting it on the
log splitter
Refer to " Sharpening Wedge " section to
sharpen the cutting edge.
Locate leak(s) and contact the dealer
was
Contact the dealer.
Check oil level for possible oil refilling.
Contact the dealer.
Loosen Bleed Screw by 3 ~ 4 rotations
before operating the log splitter
Tighten the Bleed Screw up before moving
the log splitter.
Tighten the Oil Drain Bolt with Dipstick.
Contact the dealer
10
Проверил: Р.Ч./22.08.2018г