Setup And Installation; Machine Transportation; Work Height; Tape Head Installation - Eagle T200 Operation Manual

3. Machine Setup and Installation
TAKE CARE TO AVOID DAMAGE TO THE MOTOR AND ASSEMBLY WHILE
LIFTING OR TRANSPORTING THE MACHINE!
3.1 Transportation
Use a fork lift or tow motor to remove the machine from its shipping container or pallet.
3.2 Working Height Adjustment
While elevated, install the 4 casters on the legs. Set each leg to the same height to ensure the machine is
level when placed onto the ground.
The working height should be set such that the operator is able to comfortably reach the roller table while
maintaining approximately 4in (100mm) of distance from the machine.

3.3 Tape Head Installation

Rest the upper tape head on the carriage placing the notches in the rear of the tape head onto the
supporting shaft. Pull out the pin rod by the key ring, lower the tape head and release the key ring. For
the lower tape head, remove the front supporting shaft. Rest the rear of the tape head on the rear
supporting shaft. Place the front supporting shaft on the angled notches in the front of the tape head and
lower the tape head down guiding the pin into the notches in the frame.
Check tape cutter position and adjust as needed.
- 5 -