Signal Words; Hazards Of Improper Use - Vestil MPU-AC GEN2 Instruction Manual

Table of Contents

SIGNAL WORDS

This manual uses SIGNAL WORDS to identify hazards that could occur while using this product. DANGER,
WARNING, and CAUTION draw attention to hazards likely to cause personal injuries. Each signal word implies a
specific level of injury. NOTICE is used to indicate hazards likely to result in property damage. The following are
definitions for each word:
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or SERIOUS
INJURY. Use of this signal word is limited to the most extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or SERIOUS
INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE
injury.
Identifies practices likely to result in product/property damage, such as operation that might
damage the product.

Hazards of Improper Use:

We strive to identify all hazards that could occur while using our products, but no manual can address every
risk. The most effective means for avoiding injury is to exercise sound judgment whenever using this device.
Read the entire manual carefully before installing, using, or servicing the product. Vestil recommends that you
contact its Technical Service Department
You should also contact the TSD if you believe that a necessary instruction is missing or inaccurate.
Improper or careless operation might result in serious personal injuries.
• Read and understand the entire manual before using or servicing the power unit. Read the manual to
refresh your understanding of proper use and maintenance procedures whenever necessary.
• All wiring to electrical power supplies must conform to the national electrical code (NEC) as adopted in your
location (where the product is used). Having all necessary wiring installed only by licensed electricians is
strongly recommended.
• Only authorized, qualified personnel should perform service on the electrical system.
• DO NOT service this power unit unless the product it provides power to (e.g. cart, table, lift, etc.) is unloaded.
Read the "Inspections &
recommended maintenance configuration. If repairs are necessary, ONLY install manufacturer-approved
replacement parts.
• DO NOT use the power unit unless it is in normal condition (see
• Watch the cylinder while extending and retracting the piston. It should move smoothly. Watch for binding or
jerky movement and listen for unusual noises. Tag the unit "Out of order" and do not use it if you observe
anything abnormal.
• DO NOT continue to press the UP button if the piston is fully extended.
• DO NOT use the power unit UNLESS all labels are in place and readable (see
• DO NOT modify this power unit in any way. Modifications automatically void the limited warranty and might
make the unit unsafe to use.
Proper use and maintenance are essential for this product to function properly.
• Periodically lubricate moving parts.
• Keep the product clean & dry. Only use and store the product indoors.
• Only use approved replacement parts. To order replacement or spare parts for this equipment, contact the
factory.
Table of Contents
Rev. 11/27/2018
(the "TSD") if you have any questions about instructions in the manual.
Maintenance" section of your product owner's manual. Put the product into the
Copyright 2018 Vestil Manufacturing Co.
MPU-AC GEN2, MANUAL
"Inspections & Maintenance" on p. 20).
"Labeling diagram" on p. 20).
Page 2 of 23