Site Preparation - Air Burners 100 Series Operating Manual

Self-contained refractory walled air curtain burner
Table of Contents

Advertisement

S100 Refractory Walled Air Curtain Burner with HATZ 3H50 / 4H50 Diesel Engine
OPERATING MANUAL

SITE PREPARATION

THE GOALS TO GOOD SITE PREPARATION ARE:
To place the FireBox for easy access.
To sort the waste wood pile.
To organize the inflow of new wood waste.
When locating the firebox, consider access for your truck and trailer to load and unload
the firebox. Ensure there is enough room to maneuver your truck and trailer.
Consider where the waste piles will be located. We generally recommend two waste
piles (explained in next section).
Consider the predominate wind direction. Hot embers will be escaping from the Fire-
Box during all burning operations.
Consider where and how you will empty the firebox. If you are going to 'drag' the Fire-
Box to empty it, ensure there is room and the soil conditions are not too soft. If you are
going to excavate the ash out, then consider where you will dump it. In most cases
cold ash can be reapplied to the land. Check your local ordinances.
Once the box is in position, it is important to place dirt around the inside bottom of the
FireBox to close any openings under the skids that may be caused by uneven terrain
as shown on page 4. This will prevent smoke and heat from escaping. Pay particular
attention to the seal for the forward (engine side) wall. Any openings under the panels
or forward skid will allow heat from the fire to reach the area below the engine deck.
This could cause the engine deck to become hot enough to burn the paint and be a
hazard to someone standing on the deck.
Never dig a pit in the center of the firebox. This will make it hard to seal the inside of
the box and the walls of the pit can deteriorate during operation allowing smoke and
heat to escape from the FireBox or reach the area below the engine deck creating a
hazard for anyone standing on the deck and will void the Air Burners Warranty.
DANGER: This machine DOES NOT prevent hot embers from escaping.
This machine is designed primarily as a pollution control device to reduce
the smoke generated from burning clean wood waste.
Page 13 of 32
(Vers.09.14.2021)

Advertisement

Table of Contents
loading

This manual is also suitable for:

S119S119rS116S116rS330S327 ... Show all

Table of Contents