HP rp5700 Setup Utility Manual page 11

Table 3 Computer Setup—Storage (continued)
DPS Self-Test
Boot Order
ENWW
NOTE: The RAID device driver must be installed prior to attempting to boot from a RAID volume.
If you attempt to boot from a RAID volume without the required device driver installed, the system
will crash (blue screen). Also, do not select the RAID option while the DriveLock feature is enabled
on any attached hard drives. Doing so will cause the DriveLocked drives to remain locked and
inaccessible during subsequent reboots until another SATA Emulation mode is selected.
For more information on RAID, see Redundant Array of Independent Disks (RAID) on dc7700 and
dx7300 Business Desktops Using Intel Matrix Storage Manager at http://www.hp.com/support.
Select your country and language, select See support and troubleshooting information, enter
the model number of the computer, and press Enter. In the Resources category, click Manuals
(guides, supplements, addendums, etc). Under Quick jump to manuals by category, click
White papers.
SATA 0 and 2
Allows you to enable or disable DOS and boot accesses to the Primary channel of the first SATA
controller. This feature only applies when SATA Emulation = IDE.
NOTE: Advanced operating systems like Windows may reenable the channel.
SATA 1 and 3
Allows you to enable or disable DOS and boot accesses to the Secondary channel of the first SATA
controller. This feature only applies when SATA Emulation = IDE.
NOTE: Advanced operating systems like Windows may reenable the channel.
Allows you to execute self-tests on ATA hard drives capable of performing the Drive Protection
System (DPS) self-tests.
NOTE: This selection will only appear when at least one drive capable of performing the DPS self-
tests is attached to the system.
Allows you to:
●
Specify the order in which attached devices (such as a USB flash media device, hard drive,
optical drive, or network interface card) are checked for a bootable operating system image.
Each device on the list may be individually excluded from or included for consideration as a
bootable operating system source.
●
Specify the order of attached hard drives. The first hard drive in the order will have priority in
the boot sequence and will be recognized as drive C (if any devices are attached).
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Shortcut to Temporarily Override Boot Order
To boot one time from a device other than the default device specified in Boot Order, restart the
computer and press F9 when the monitor light turns green. After POST is completed, a list of bootable
devices is displayed. Use the arrow keys to select the preferred bootable device and press Enter.
The computer then boots from the selected non-default device for this one time.
Computer Setup (F10) Utilities 5