Table of Contents
Advertisement
Power Consumption:
Rated microwave power output:
Operation Frequency:
Outside Dimensions:
Oven Cavity Dimensions:
Oven Capacity:
Cooking Uniformity:
Net Weight:
1.
Make sure that all the packing materials are
removed from the inside of the door.
2.
WARNING: Check the oven for any damage,
such as misaligned or bent door, damaged door
seals and sealing surface, broken or loose door
hinges and latches and dents inside the cavity or
on the door. If there is any damage, do not
operate the oven and contact qualified service
personnel.
3.
This microwave oven must be placed on a flat,
stable surface to hold its weight and the heaviest
food likely to be cooked in the oven.
4.
Do not place the oven where heat, moisture, or
high humidity are generated, or near combustible
Operation of the microwave oven can cause
interference
to
your
equipments.
When there is interference, it may be reduced or
eliminated by taking the following measures:
1.
Clean door and sealing surface of the oven.
2.
Reorient the receiving antenna of radio or
television.
SPECIFICATIONS
INSTALLATION
RADIO INTERFERENCE
radio,
TV,
or
similar
230-240V~50Hz, 1200W(Microwave)
700W
2450MHz
262mm(H)×452mm(W)×348mm(D)
198mm(H)×315mm(W)×297mm(D)
20Litres
Turntable System
Approx.10.5kg
materials.
5.
For correct operation, the oven must have
sufficient airflow. Allow 20cm of space above
the oven, 10cm at back and 5cm at both sides.
Do not cover or block any openings on the
appliance. Do not remove feet.
6.
Do not operate the oven without turntable, roller
support, and shaft in their proper positions.
7.
Make sure that the power supply cord is
undamaged and does not run under the oven or
over any hot or sharp surface.
8.
The socket must be readily accessible so that it
can be easily unplugged in an emergency.
9.
Do not use the oven outdoors.
3.
Relocate the microwave oven with respect to
the receiver.
4.
Move the microwave oven away from the
receiver.
5.
Plug the microwave oven into a different outlet
so that microwave oven and receiver are on
different branch circuits.
4
Advertisement
Table of Contents
