Texas A/S Hobby 600BR Instruction Manual page 15

Spark plug maintenance
•
Remove the spark plug cap.
•
Brush away any dirt and deposit of the spark plug.
•
Loosen the spark plug using a spark plug socket.
•
Check the insulation is intact.
•
Clean the spark plug using a wire brush.
•
Measure the electrode gap 0.7–0.8 mm. Avoid
damaging the electrode. If it is damaged, replace it
with a new one.
•
Refit the spark plug.
•
Refit the spark plug cap.
Storage
•
If the machine is likely to be stored unused for
prolonged periods, follow the instructions below.
This will ensure longer machine lifetime.
•
Use a garden hose to wash off soil and dirt.
Remove any grass, etc. from the rotor shaft. The
chassis number should only be cleaned with a
damp cloth to avoid unnecessary wear. Avoid using
a high-pressure washer during cleaning.
•
Wipe the tiller with a damp cloth so that all surfaces
are clean. Wipe the surfaces down with an oily cloth
to prevent rust.
•
Always store the machine in a dry, clean location.
Troubleshooting
The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
4. See separate motor instructions for further
troubleshooting.
The motor is not running smoothly
1. Ensure the throttle control is not set to max.
2. Check there is fresh gas in the tank.
The blades will not rotate
1. Check for stones lodged between the blades.
2. Release any stones by removing the blades.
3. Check the cables are in good working order and
fitted correctly.
4. Check the belt is in good working order and fitted
correctly.
5. Ensure the belt tensioner is adjusted correctly.
The blades will not stop
1. Stop the engine and contact your dealer.
Noise, vibration and precautionary measures
1. Long-term exposure to noise levels exceeding 85
dB (A) are damaging. Always use ear defenders
when the machine is being used.
2. Reduce the running speed of the motor to reduce
vibration and noise levels.
3. To reduce noise levels further, only use the machine
in an open environment.
4. Vibrations can be reduced further by holding the
handle firmly.
5. To avoid disturbing others, the machine should only
be used during the daytime.
6. Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with
steel toecaps.
7. Take a 30-minute break every 2 working hours.
8. A worn belt has to be replaced/ serviced by a
authorized dealer
Specification
Model
Length (mm)
Width (mm)
Height (mm)
Weight (kg)
Forward gears
Reverse gears
Handle
Working width
Working depth
Rotation speed,
blades
Grease type
Brand
Model
Capacity
Max power
Sound power level of
machine
9
Hobby
Hobby Hobby
600BR 600TGR
1210 1210
590 590
1020 1020
45 46
1
1
Adjustable Adjustable
50 cm 50 cm
33 cm 33 cm
91 rpm 91 rpm
Multifak EP-0 Multifak EP-0
Engine
B&S PowerLine
650E TG565
190 CC 159 CC
2.61 kW 3.00 kW
3400rpm 3400rpm
LWA: 91 dB(A) LWA: 92 dB(A)
1
1