Haier LE65S8000UG Owner's Manual page 14

CHANNEL
Channels – Display the scan sub-menu based on
Channel installation mode – Select on-screen display
channel sources. You can select the signal type.
Antenna –
Set the signal type to antenna. When set to
Antenna,the TV can receive analog and digital (DVBT/T2)
broadcasting signals.
Cable –
Set the signal type to cable. When set to Cable,
the TV can receive analog and QAM broadcasting signals
Preferred Satellite/General Satellite –
type to Satellite. When set to Satellite, the TV can receive
Satellite broadcasting signals.
Auto Channel Update – Press OK button to choose ON/OFF.
When selecting ON, the system will automatically scan and
update channels after 5 minutes of standby.
Parental controls –
Press
option then press OK button to enter the sub-menu.
Audio Channel
– Press
option then press OK button to enter the sub-menu.
Open source licenses – Press
option then press OK button to enter the sub-menu.
Antenna
1.Menu->Settings->Channel->Channel Installation Mode
enter, choose Antenna.
2. Enter Menu->Settings->Channel->Channels.
Set the signal
button to select the
button to select the
button to select the
3. Channel Scan directly enters the ATV+DTV
automatic search platform interface of Antenna.
Update Scan: Re-automatically search for frequency
points outside the station.
Analog Manual Scan: Manual ATV search station.
After input the frequency point, you can select up
or down search station.
Single RF Scan: DTV manual search, left and right
after selecting RF Channel, directly OK search.
Cable
1.Menu->Settings->Channel->Channel Installation
Mode, select Cable.
2. Enter Menu->Settings->Channel->Channels.
11