Makita DG002G Instruction Manual page 7

Setting up tool
CAUTION:
Always be sure that the front
handle, side handle and reaction receiver are
installed securely before operation.
NOTICE:
Do not over tighten the bolts. It may
damage the tool.
Installing the side handle
Remove the bolts shown in the figure from the tool.
Keep the bolts so that they are not lost.
1
Fig.2
► 1 . Bolt
Place the side handle on the tool.
Tighten the all four bolts temporarily, and then securely
tighten the bolts using the wrench.
3 2
1
Fig.3
► 1 . Side handle 2. Bolt A 3. Bolt B
1
2
3
Installing the reaction receiver
Place the reaction receiver so that the bar of the reac-
tion receiver comes to the left side of the operator.
Adjust the position of the reaction receiver so that the
axis of the spindle is in the center of the operator's body.
Fasten the bolts firmly.
1
2
Fig.4
► 1 . Bar of the reaction receiver 2. Bolt C
7 ENGLISH
2
1