How To Set; Auto Off Time; Level Unit Select; Frequency Step In - Pico Macom PICO-PRO User Manual

Pico Pro Manual 06.qxd
Pico-Pro User Manual
PICO-PRO

3.2 HOW TO SET

Press "2ndF" then "7".
2ndF
LCD display as follows:
7
L M
Press key or to select menu (in three
screens) then press key "ENT" to enter
selected SET mode. Press Key "CLR" to
escape to testing mode.
At any time during this menu press
to select desired choice, and then press "ENT"
to confirm and escape to previous menu.
Or press key "CLR" to cancel the current
operation and return to previous menu.

3.2.1 Auto Off Time

When the mark is pointed to "AUTO OFF
TIME", press "ENT", the LCD will display:
4
Rev. 03/06
4/10/06 3:20 PM
L M
or
Ph: 800-421-6511
www.picomacom.com
Page 4

3.2.2 Level Unit Select

When the mark (arrow head) is pointed to
LEVEL UNIT, press "ENT" to confirm; LCD
displays:
Select the desired output power level "dBuV"
or "dBmV".

3.2.3 Frequency Step In

When mark (arrow head) is pointed to
"FREQUENCY STEP", press "ENT" to
confirm; LCD Displays:
Select the desired frequency step:
"50kHz","100kHz" or "1MHz"

3.2.4 Tilt Channel Set

This function helps you check the tilt in your
multi-channel headend system. You can
choose 7 different channels in ascending
order (you can choose the channel number by
using up and down arrow). Using F1 or F4 you
can go to the next level of channel to be
selected. 1 being the lowest channel and 7
being the highest channel in your system,
it will show you the difference between the
lowest and highest signal level. Accordingly
the user will know if equalizer is needed or
not. Once all channels have been selected
press <ENT> to confirm and press <2
<TILT> to check your selected channel levels.
nd > and