GMC Yukon XL 2013 Owner's Manual page 38

2-4 Keys, Doors, and Windows
(Unlock): Press once to unlock
only the driver door. If
again within three seconds, all
remaining doors unlock. The interior
lamps may come on and stay on for
20 seconds or until the ignition is
turned on.
If enabled through the DIC, the turn
signal lamps flash twice to indicate
unlocking has occurred. See Vehicle
Personalization (With DIC Buttons)
on page 5 45. If enabled through
the DIC, the exterior lights turn on
briefly if it is dark enough outside.
See Approach Lighting under
Vehicle Personalization (With DIC
Buttons) on page 5 45.
Pressing on the RKE transmitter
disarms the content theft-deterrent
system. See Vehicle Alarm System
on page 2 13.
m
(Liftglass): Press and hold to
unlock the liftglass.
8
(Power Liftgate): Press and
hold to open and close the liftgate.
is pressed
The taillamps flash and a chime
sounds to indicate when the liftgate
is opening and closing.
(Vehicle Locator/Panic
Alarm): Press and release to
locate the vehicle. The turn signal
lamps flash and the horn sounds
three times.
Press and hold
two seconds to activate the panic
alarm. The turn signal lamps flash
and the horn sounds repeatedly for
30 seconds. The alarm turns off
when the ignition is moved to ON/
RUN or
ignition must be in LOCK/OFF for
the panic alarm to work.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
for more than
is pressed again. The
When the replacement transmitter is
programmed to this vehicle, all
remaining transmitters must also be
reprogrammed. Any lost or stolen
transmitters will no longer work
once the new transmitter is
programmed. The vehicle can have
a maximum of eight transmitters
programmed to it. See your dealer
to program transmitters to the
vehicle.
Battery Replacement
Replace the battery if the REPLACE
BATTERY IN REMOTE KEY
message displays in the DIC. See
REPLACE BATTERY IN REMOTE
KEY under Key and Lock
Messages on page 5 39 for
additional information.
When replacing the
battery, do not touch any of the
circuitry on the transmitter. Static
from your body could damage the
transmitter.