Table of Contents
Advertisement
1
•
Remove the #8 x ¾" (1,9 cm) screw from the battery
retainer. Lift to remove the battery retainer from
the vehicle.
•
Lift to remove the battery from the battery compartment.
BATTERY CHARGING
7
Battery must be upright
while charging.
2
•
Plug the battery connector into the charger connector.
•
Plug the charger into a standard wall outlet.
Notes:
- If power flow to the wall outlet is controlled by
a switch, make sure the switch is "ON".
- Use the charger only in a wall outlet. Do not plug the
charger into a ceiling outlet.
•
Once the battery is charged, disconnect the battery
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing
your battery. If your battery is already installed in
your vehicle, simply re-connect the motor harness
connector to the battery.
•
You do not need to remove the battery from your
vehicle to recharge it.
•
Before charging the battery, examine the battery case
for cracks and other damage which may cause sulfuric
acid (electrolyte) to leak during the charging process.
If damage is detected, do not charge the battery or use
it in your vehicle. Battery acid is very corrosive and
can cause severe damage to surfaces it contacts.
•
Do not place the battery on a surface (such as kitchen
counter tops) which could be damaged by the acid
contained inside the battery. Take precautions to
protect the surface on which you place your battery.
•
Charge the battery in a well ventilated area.
V4100pr-0920
Advertisement
Table of Contents
