Installation Procedure; Front And Side Views - Pico Macom MPC-HSS Installation And Operation Manual

Installation Procedure

MPC-HSS
2
1
POWER
3

Front and Side Views

1. Power: This LED will illuminate when module is powered on.
2. Top Edge: This edge aligns with top guide channel of chassis.
3. Bottom Edge: This edge aligns with bottom guide channel of chassis.
Installation
1. Align the top and bottom edge of module with the guide channel in chassis.
2. Slide module into chassis until firmly seated and front LED has illuminated.
MODULE REPLACEMENT
1. Remove by sliding module out of the front of chassis
2. Insert replacement by Aligning the top and bottom edge of module with the guide channel in chassis.
3. Slide module into chassis until firmly seated and front LED has illuminated.
OPERATION & CARE
Dos & Don'ts
• Always operate in a cool well ventilated environment.
• Always provide a stable conditioned power source.
• Heed all safety warnings and obey all environmental and electrical operating requirements.
• To clean, use a damp cloth only and clean only with mild soap.
• Do not use solvents or harsh detergents.
• Do not use this product for purposes other than intended.
Ph:800-421-6511 www.picomacom.com
6
Rev. 06/03