Faults And What To Do About Them - Siemens WM6YH890ES Instruction Manual And Installation Instruction

Faults and what to do about them.

en
Faults and what to do about them.
Faults
Water is leaking from the
machine.
The appliance is not filling
with water.
The dispenser is empty
and the fill level indicator
is not flashing.
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Detergent/fabric softener
has congealed in the
dispensers.
The door will not open.
The programme does not
start.
The drum briefly jerks or
judders after the
programme has started.
The water is not draining.
Water is not visible in the
drum.
The spin result is not
satisfactory.
Laundry wet/too damp.
The appliance restarts the
spin cycle several times.
66
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the supply hose.
■
Have you pressed the Ü button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the supply hose kinked or trapped?
■
Is the drawer cover/connector dirty? Cleaning ~ Page 49
■
Has the detergent drawer been pushed in correctly? Insert correctly.
■
~ Page 60
Dispenser(s):
1. Empty and clean.
2. Refill. ~ Page 47
Clean and refill the dispensers.
The safety function is activated. Stop the programme? ~ Page 45
■
Is the w childproof lock activated? Deactivate. ~ Page 44
■
Is $ selected (Rinse Stop = no final spin)? ~ Page 45
■
Can the door only be opened by the emergency release? ~ Page 63
■
Have you pressed the Ü or Finish in button?
■
Is the door closed?
■
Is the w childproof lock activated? Deactivate. ~ Page 44
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Is $ selected (Rinse Stop = no final spin)? ~ Page 45
■
Clean the drain pump. ~ Page 61
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
Is Less Iron selected (depending on the model)? ~ Page 48
■
Is the selected speed too low? ~ Page 40
■
Not a fault – the unbalanced load detection system is adjusting an imbalance.