Medisana 60258 Instruction Manual page 18

GB
2 Operating
2.2
Operation
14
Always make sure that the foot warmer is not creased or folded while it is in
use. You must always use the foot warmer with the cover.
Switch the appliance on with the sliding switch on the control unit. Never use
a clock timer!
Switch level 0 = Appliance switched off
Switch level 1 = Heat low
Switch level 2 = Heat medium
Switch level 3 = Heat high
During switch level 1, 2 and 3 the indicator light is illuminated, showing the
adjusted level number contemporaneously. You can now enjoy the pleasant
warmth at your feet.
After approx. 90 minutes the foot warmer automatically switches off. To switch
the foot warmer on again, you must first move the sliding switch to position
0. After approx. 5 seconds you can switch the foot warmer back on by sliding
the switch to level 1, 2 or 3. You can stop using the appliance at any time by
moving the sliding switch to position 0. Disconnect the plug from the mains
socket when you are not using the foot warmer.
WARNING
When the foot warmer is in operation, the control unit may
warm up slightly. For this reason, the control unit must not be
covered or placed on the foot warmer while the appliance is
switched on.
Do not rely on your hands to test the heat of the foot warmer.
Hands are considerably less sensitive towards heat than the
rest of the body's surface. A temperature which is judged by
the hand to be slightly warm can be felt by the feet to be
unpleasantly hot.
The indicator light goes out if the safety system switches off
the foot warmer due to a fault, even if the foot warmer is still
switched on. The foot warmer must no longer be used after a
fault has occurred. This is because safe operation of the
appliance can no longer be guaranteed.