DeWalt DXPW3394 Instruction Manual page 19

Where the purchaser of this product is in Australia and is a consumer
under Australian Consumer Law, the warranty provisions herein are
to be read subject to the terms of Australian Consumer Law unless
excluded in accordance with that Law. In Australia, you are entitled to
a replacement or refund for a major failure and for compensation for
any reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the good fail to be of acceptable
quality and the failure does not amount to a major failure.
The manufacturer will honor the terms of all component warranties
and satisfy claims of the appropriate warranty provisions through a
network of factory authorized and trained Warranty Service Centers.
To make a claim under the terms of the warranty, all parts said to be
defective must be retained and available for return upon request to
a designated Warranty Service Center for warranty inspection. The
judgments and decisions of the manufacturer concerning the validity
of warranty claims are final.
Any product subject to a warranty claim-- please call the phone
numbers listed below for specific warranty instructions, procedures,
and information regarding the Warranty Service Centers.
You must present proof of purchase when making a warranty claim.
Australia Phone : 1800 841 749
New Zealand Phone : 0800 467 813
Mayo Hardware PTY LTD
4 Secombe Place Moorebank NSW 2170
Australia
Glossary
Bypass mode: Allows water to re-circulate within pump when the gun
trigger is not pulled.
Chemical hose: Feeds cleaning agents into the pump to mix with the
water. Refer to Chemicals and Cleaning Solvents.
Chemical injection system: Mixes cleaners or cleaning solvents with
water to improve cleaning effectiveness.
Choke control: Opens and closes carburetor choke valve.
CU: Cleaning Units. GPM multiplied by psi. (GPM x PSI = CU)
Fuel valve lever: Opens/closes connection between fuel tank and
carburetor.
GPM: Gallons Per Minute. The unit of measure for the flow rate of
water.
LPM: Liters Per Minute. The unit of measure for the flow rate of water
PSI: Pounds per Square Inch. The unit of measure for water pressure.
Also used for air pressure, hydraulic pressure, etc.
kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal
1000 pascals.
Quick-connect spray wand: Allows the user to quickly change out
high pressure nozzles. Refer to Spray Wand Nozzles.
Thermal relief valve: When the temperature inside the pump rises
too high the valve will open and release a gush of water in an effort
to lower the temperature inside the pump. The valve will then close.
Water supply: All pressure washers must have a source of water. The
minimum requirements for a water supply are 20 psi (138 kPa) and
5 gallons per minute.
19