Limited Warranty - State Water Heaters SSF 100 Instruction Manual

Commercial gas water heaters

Table of Contents

State Water Heaters, the warrantor, extends the following lImITeD WArrANTy to the owner of this water heater.

1. THe TANk

If the glass-lined tank in this water heater shall prove upon examination by the warrantor to have leaked due to natural corrosion from

potable water therein, during the first THree years after initial installation, the warrantor will supply a replacement tank less burner

and controls or a complete new State water heater of equivalent size and current model at the warrantor's option. Some government

agencies are requiring energy efficient standards for water heaters. In the event regulations prohibit sale of a model of equivalent

size and construction, State will provide a model which complies with the regulations of your area, in which case the consumer

will be charged the difference in price between the like replacement and the energy efficient model required. The warranty on the

replacement water heater will be limited to the unexpired term of the original warranty.

2. All oTHer PArTS

If within oNe year after initial installation of this water heater, any part or portion shall prove upon examination by the warrantor to be

defective in material or workmanship, the warrantor will repair or replace such part or portion at its option.

3. CoNDITIoNS AND eXCePTIoNS

This warranty shall apply only when the water heater is installed in accordance with local plumbing and building codes, ordinances

and regulations, the printed instructions provided with it and good industry practices. In addition, a temperature and pressure relief

valve, certified by CSA and approved by the American Society of mechanical engineers, must have been installed.

This warranty shall apply only when the water heater is:

(1)

owned by the original purchaser;

(2)

used at temperatures not exceeding the maximum setting of its thermostat;

(3)

used at water pressure not exceeding the working pressure shown on the heater;

(4)

used when operated free of the damaging effects of uncontrolled water hammer;

(5)

used when filled with potable water, free to circulate at all times;

(6)

used in a non-corrosive and non-contaminated atmosphere;

(7)

used with factory approved anode(s) installed;

(8)

in its original installation location;

(9)

in the united States, its territories or possessions, and Canada;

(10) sized in accordance with proper sizing techniques for commercial water heaters;

(11) bearing a rating plate which has not been altered, defaced or removed except as required by the warrantor;

(12) used in an open system or a closed system with a properly sized and installed expansion tank.

(13) fired at the factory rated input using the fuel stated on the rating plate;

(14) maintained in accordance with the instructions printed in the manual included with the water heater.

b. Any accident to the water heater, any misuse, abuse (including freezing) or alteration of it, any operation of it in a modified

form, or any attempt to repair tank leaks will void this warranty.

C. This warranty is void if a device acting as a backflow prevention device (check valves etc.) is installed in the cold water

supply the heater is connected to, unless an effective method of controlling thermal expansion is also installed at the

heater(s) and operational at all times.

The temperature and pressure relief valve installed on the heater is not an acceptable method.

4. ADDITIoNAl CoNDITIoNS AND eXCePTIoNS For SSX moDelS

This warranty shall apply only to SSX 100t120 models when these additional conditions are met:

• the single wall indirect heat exchanger coil is used in closed loop systems.

• the single wall indirect heat exchanger coil is filled with a mixture of distilled or de-mineralized water and propylene glycol

containing corrosion inhibitors (such as Dowfrost™) with a 50% by volume maximum dilution rate.

• the single wall indirect heat exchanger coil IS NoT filled with a toxic liquid.

• the single wall indirect heat exchanger coil is used with any heat transfer fluid other than that specified.