Parts And Features; Assembly; Operation; Storage - Briggs & Stratton 1696899 Operator's Manual

Figure 1
C
D
E
Figure 2

Parts and Features

A Brush cutter attachment
Debris guard
B

Assembly

(Figure 2)
1. Remove the existing auxiliary handle from the pole.
2. Slide clamp (H) over rubber sleeve (G).
3. Slide pole through the auxiliary handle (E).
4. Slide washer (F) over the pole.
5. Insert two screws (C) through holes in handle extension (D).
6. Line up holes in handle extension (D) with holes in
auxiliary handle (E) and holes in clamp (H). Attach
handle extension to auxiliary handle and the pole using
screws (C) and nuts on the clamp, with the distance no
less than 15cm from the coupling. Tighten with a wrench.
Make sure the direction of the auxiliary handle is opposite
to the blade.
4
A
B
F
G
H
2
Figure 3

Operation

(Figure 3)
Insert brush cutter pole into pole on power head.
1
Press button on pole to allow power head pole to lock
2
into place.
Tighten knob on power head pole.
3

Storage

When transporting or storing the brush cutter, always
remove the battery. Proper handling of the brush cutter will
reduce the risk of personal injury from the cutter blades.
3
1