Table of Contents
Advertisement
Premise:
You can modify the washing program, When the dishwasher just
runs for a short time.
released, and the appliance may have already drained the wash water. If this
is the case, the detergent dispenser must be refilled (see the section entitled
" Loading the Detergent " ).
Touch
S
tart/Pause
Button to pause the machine when the door is closed ,Touch
Program
Button more than three seconds the machine will be in stand by state ,
then you can change the program to the desired cycle setting (see the section
entitled " Starting a wash cycle. . ." ).
NOTE: If you open the door during washing, the machine will pause. When you
close the door , the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
a) One of the program lights on----------stand by or pause
b) One of the program lights blinking----- run
If you open the door when washing, the machine will pause. When you close the door , the machine
will keep on working after 10 seconds.
Your model has broken remember function, the machine will go on to finish the selected
program
A forgotten dish can be added any time before the detergent cup opens.
1
Touch the
S
tart/Pause
2
Open the door a little to stop the washing.
3
After the spray arms stop working,you can open the door
completely.
When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
It is dangerous to open the door when washing,
because the hot water may scald you.
Otherwise, the detergent may have already been
after the power cut
.
button
4
Add forgotten dishes.
5
Close the door
6
Touch the
S
tart/Pause
after 10 seconds.
12
button, the dishwasher will run
Advertisement
Table of Contents
