Honda ACCORD SEDAN 2019 Owner's Manual page 70

uuChild SafetyuSafety of Infants and Small Children
Straight top tether type in seat
position with fixed headrest
Tether Strap
Hook
Anchor
Other top tether type in seat
position with fixed headrest
Tether Strap
Hook
Anchor
68
Straight top tether type in seat position
with fixed headrest
5. Route the tether strap over the top of the
head restraint and secure the tether strap
hook to the anchor.
Other top tether type in seat position
with fixed headrest
5. Route the tether strap over the side of the
head restraint and secure the tether strap
hook to the anchor.
All models
6. Tighten the tether strap as instructed by the
child seat manufacturer.
7. Make sure the child seat is firmly secured by
rocking it forward and back and side to
side; little movement should be felt.
8. Make sure any unused seat belt that a child
can reach is buckled, the lockable retractor
is activated, and the belt is fully retracted
and locked.
1Installing a LATCH-Compatible Child Seat
WARNING
3
Do not use the lower inner anchors of the
outer rear seats to secure a LATCH-
compatible child seat to the rear center
seat, unless the manufacturer's instructions
for that system permit the use of inner
anchors with the stated spacing.
Installing a LATCH-compatible child seat in the
rear center seat
Each outer rear seat is equipped with a pair of lower
anchors which are used to secure a LATCH-
compatible child seat. The rear center seat, however,
is not equipped with anchors of any kind. The inner
and outer anchors are spaced apart at a standard
distance of 11 inches (280 mm). The distance
between the two inner anchors is 15.4 inches (390
mm).
LATCH-compatible restraint systems that are fitted
with rigid-type attachments cannot be installed in the
rear center seat. However, a system fitted with
flexible-type attachments can be installed in the
center seat, provided that the manufacturer's
instructions for that system permit the use of the
inner anchors with the stated spacing.
Before seating a child, make sure that the system is
properly attached to both the lower anchors and
tether anchors.