uuReplacing Light BulbsuTaillight, Brake Light
Taillight, Brake Light
When replacing, use the following bulbs.
Taillight: LED
Brake Light
*
: LED
Back-Up Light: 16 W
Holding Clip
Bulb
* Not available on all models
636
*
and Back-Up Light Bulbs
*
and Back-Up Light Bulbs
1. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
Driver side
2. Turn the socket counter-clockwise and
remove it.
3. Remove the old bulb and insert a new bulb.
Socket
1Taillight, Brake Light
*
and Back-Up Light Bulbs
Taillights and brake lights
*
are LED type. Have an
authorized Honda dealer inspect and replace the light
assembly.
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Clip
Insert the clip with the pin raised, and push until it is flat.
Push until the
pin is flat.