Table of Contents
Advertisement
INSTALLATION
16
1
Remove the 2 screws on the back.
2
Pull the top cover backwards after removing
the two screws and then lift it up to remove it.
3
Remove the locating pins on the top by using a
Phillips screw driver.
NOTE
• When the appliance is correctly leveled, there
should be no slant, stickiness or rubbing sound
when the door is opened.
Levelling the Appliance
Checking the Level
Levelling the appliance prevents unnecessary
leakage and poor washing. Check whether the
appliance is perfectly level after installation.
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
NOTE
• The appliance is not level if there is a rubbing
sound or stickiness when the door is opened.
Adjusting and Leveling the
Appliance
When the appliance is not perfectly level, turn the
adjustable feet until the appliance no longer
wobbles.
• Turn the adjustable feet clockwise to raise or
turn the adjustable feet counterclockwise to
lower from front-to-back, side-to-side and
corner-to-corner.
NOTE
• Place the appliance on a solid, level floor.
• Do not install the appliance on an elevated
surface.
Case 1. The Door is Slanted to the
Right
1
Unscrew (counter-clockwise) the rear left leg
and correct the level.
Advertisement
Table of Contents
