Epson R210 Instructional Manual page 4

Attention:
1. After installing the CI System, do not remove the cartridges unless it is necessary. If cartridges are removed,
Immediately place cartridges upside down with ink exit holes facing in an upward position to avoid leaking.
If cartridges are removed for more than an hour, please cover ink exit holes with tape.
2. When you are printing do not move the ink tank up or down. Keep it stable and at the same level as the
printer.
3. Store at 15-35 degrees Celsius.
4. The ink and cartridge flow have been designed and tested to function as a system. We recommend you use
the specially designed ink Low Foam Ink in the CIS for optimal results.
Caution:
1. Do not ingest ink and keep out of reach of children
2. Do not leave under sunlight or in extreme weather conditions
3. Do not drop ink tank or handle roughly
Thank you for purchasing the Continuous Ink System: We hope you found this manual useful.
If the ink tank is full of ink computer shows a message
That the cartridges are empty. The printer keeps track of
1 how much ink is being used and thinks that the cartridge
should be empty as you will have to reset the cartridges
chips.
2 Banding or white lines in my print outs.
3 When I have completed a printing job the ink is
siphoning down the tubing.
4 The tubing is getting caught inside the printer resulting
in an error message"paper loading error".
5 After refilling the tanks the printer won't print
6 After installing the CI system the printer isn't
recognizing some of the cartridges.
If you are still unable to fix the problem call your dealer
for support.
Problem
Troubleshooting tips
Take out the cartridges. Turn off the printer and wait a couple
of minutes. Put the cartridges back in, turn the printer on and
continue printer.
There is air in the system or cartridges. Try running a couple of
cleaning cycles. If white lines continue use the provided
syringe to suck the air out of the bottom of the trouble cartridge
and you can dump the ink that fills the syringe back into the top
of the CI system.(Make sure to thoroughly rinse the syringe
when completed.)
The shipping plugs need to be removed before installing and
replaced with the air breathers to eliminate any pressure being
built up in the system, along with protecting the ink from
contamination. Also the ink tank should be sitting on the same
level surface as the CI system. If the air breathers are covered
with dried ink, you can rinse the air breather and dry
thoroughly to regain use.
If the tubing not adjusted correctly, if it's to short or to long
causing it to slap the inside of the printer, Please adjust.
If the ink is dumped into the system to quickly then it allows
air to enter the system. Use the provide syringe to extract ink
and air from the bottom of the cartridges. The ink that fills the
syringe can be slowly dumped back into the top of the ink tank.
Remove the cartridges, turn off the printer and reinstall the
cartridges. Then you can continue printing.
Suggestion