Haylou GT6 - True Wireless Earbuds Manual

Overview

How to Wear

Gently insert the earbud into the ear canal, adjust the earbud to the most comfortable wearing state.

When calling, adjust Mic towards mouth to gain better talking experience.

How to Charge

For first time use, please remove the isolation film on the charging contacts of both earbduds. Then fully charge the charging case and earbuds.

Plug in the charging cable to charge the earbuds and the charging case at the same time. The charging indicator light will be solid red when the charging case is not fully charged. The indicator light goes out after fully charged.

Power-on

How to Pair

Automatic connection: Take two earbuds out from the charging case simultaneously, the earbuds will power on and connect with each other within 5s. When lights on both earbuds flash white slowly, open device Bluetooth and search "Haylou GT6", finally click it to complete the connection.

Put the earbuds back to the charging case and repeat the above operation if the connection fails. After the first connection, the earbuds can be automatically connected to the last paired device (Bluetooth needs to be turned on).

Switch between mono and stereo mode: It is stereo mode after two earbuds are successfully connected. Put one back into the case to power off, the other will enter mono mode. Or pick it up again to resume stereo mode.

Manual connection: When earbuds are turned off, manually turn on the two earbuds. Wait 5s for the earbuds to turn on and connect with each other. When lights on both earbuds flash white slowly, turn on device Bluetooth to connect.

Functions

Short press MFB button
Play/Pause music

Double click right MFB button
Skip track forward

Double click left MFB button
Turn on/off low latency mode when playing games

Short press MFB button
Answer/End call

Triple click MFB button
Summon voice assistant when standby

Answer the Second Call

When there is a new incoming call during a call, click the MFB button to keep the first call and answer the second call, then double click the MFB button to switch back to the first call and keep the second call. During a three-party call, click the MFB button to hang up the current call.

Factory Setting

1. The earbuds are charging in the charging case (light glows solid red or white after fully charged within 1 minute).
2. Long press the two earbuds simultaneously for about 10s, release after LED alternately flashes red and white 3 times.
3. Take the earbuds out from the charging case until LED flashes white slowly.
4. Clear phone pairing records, follow the pairing steps to complete Bluetooth connection.

Audio only Outputs from Single Earbud

It's unusual indeed, please refer to the following operation steps if the situation occurs:

1. Put the earbuds back into the charging case, and then take them out again to connect.
2. Refer to the reset steps to reconnect the Bluetooth device.

Other Charging Problems

1. White indicator light goes out after 1 minute. The earbuds have been fully charged.
2. When the charging case is out of power, the earbuds cannot be charged and keep the original connecting status.
3. The indicator light will go out after the charging case is fully charged.

Package List

Earbuds, charging case, user manual.