Advertisement
For more information about configuring the NI WSN system, refer
to Start»All Programs»National Instruments»NI-WSN»
Configuring WSN in MAX.
Step 5. Attach Sensors and Signal Lines
Attach sensors and signal lines to the terminal block or accessory
terminals for each node. For device pinouts, refer to the device
documentation.
Step 6. Start Using the NI WSN System
To start using the NI WSN system, complete the following steps:
1. Open a new LabVIEW project.
If the NI CompactRIO controller is on the local subnet,
complete the following steps:
a. Right-click the project name and select New»Targets and
Devices. In the Add Targets and Devices on My Project
dialog box, select Existing target or device and expand
the Real-Time CompactRIO folder. When you expand
the Real-Time CompactRIO folder, the network is
scanned for any connected NI CompactRIO devices. Wait
for device detection.
© National Instruments Corp.
11
NI 9795 Getting Started Guide
Advertisement
