Troubleshooting - EINHELL BG-RS 2540/1 CB Original Operating Instructions

Anleitung_BG_RS_2540_1_CB_SPK1__ 26.08.14 07:23 Seite 18
GB

10. Troubleshooting

Fault
The motor does not start
Material is not drawn in by the
shredder
The material is not shredded
properly
18
Cause
Power failure
Motor circuit breaker has been
triggered
The safety switch is not making
contact
The switch for selecting the
direction of rotation is in its center
position.
The shredding blade is running in
reverse.
Material blockage in the filling
funnel
The shredding blade is jammed
The counter blade is not set
correctly.
Remedy
Check the mains lead, plug and
fuse.
Press the Reset button (see point
6.5)
Insert the debris box correctly and
push the safety switch upwards
until it engages
Set the direction of rotation on the
switch
Change the direction of rotation.
Change the direction of rotation
and pull the material out of the
funnel. Feed in thick branches
again so that the blade does not
immediately engage again in the
notches it previously cut.
Change the direction of rotation.
The blade will now release the
jammed material.
Adjust the counter blade. See
section 6.8 on how to do so.