Haier 1D 60 7 Series User Manual page 20

1 O - lnstallation
10.1 Unpacking
&
WARNING!
The appliance is heavy. Always handle with at least two persons.
►
Keep all packaging materials out of childrens reach and dispose them in an
►
environmentally friendly manner.
Take the appliance out of the packaging.
Remove all pack aging materials.
►
10.2 Envirconmental conditions
The room temperature should always be between 10
the temperature inside the appliance and its energy consumption. Do not install the
appliance near other heat-emitting appliances (ovens, refrigerators) without isolation.
10.3
-�-_
-r �----
10.4
2
10.3 Space requirements
D4
Required space to open the door (Fig. 10.3):
D2 D3
Width
in mm
W1 W2
595 955 592
FOR a free standing appliance: this refrigerating
appliance is not intended to be used as a built-in
appliance.
10.4 Ventilaton cross-section
To achieve sufficient ventilation of the appliance for
safety reasons, the information of the required
ventilation cross sections must be observed {Fig. 10.4).
10.5 Aligning the appliance
The appliance should be placed on a flat and a solid
surface.lf the appliance is placed on a pedestal, strong
and fire-resistant materiai must be used.Never use the
form packing materiai as a pedestal.
1. Tilt the appliance slightly backwards {Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bl:fmping
on the diagonals. The slight swaying should be the
same in both directions. Otherwise the frame can
warp; possible leaking door seals are the result. A low
tendency to the rear eases the closing of the door.
° °
C and 43 (,since it can influnce
Depth
in mm
D1 D2 D3
1105 1215
EN
Distance to wall
in mm
D4
100