Menu Of Various Parameters - AMC VOX-4W Installer Manual

test -- Contact ID Call
NOT READY
CALLING
RING
IN COMUNICATION – online. Waiting for a signal from the receiver
SENDING DATA
TEST OK
TEST KO
To exit from the test phase, press the key #

Menu oF varIous ParaMeters

CARD TAMPER
this parameter enables or disables the anti-opening protection of the sim card slot.
Once you have accessed the menu, press enter, program the value (0=disabled 1=enabled) and confirm by pressing enter.
KEY BUZZER
this parameter either enables or disables key sound.
Once you have accessed the menu, press enter, program the value (0=disabled 1=enabled) and confirm by pressing enter.
VARIOUS PARAMETERS: lIfE TEST
this parameter indicates after how many hours the system must regularly inform the user that the life test result is successful and
that therefore the gsm system works properly. (the value to be inserted is expressed in hours)
Once you have accessed the menu, press enter, press CanCel to cancel the current value, program the new value, and press
enter to confirm . (Can be programmed between 0 to 240) the default value is 0 = disabled
VARIOUS PARAMETERS: ASwR. RIngS
indicates the number of rings the system waits for before answering the call.
Once you have accessed the menu, press enter, press CanCel to cancel the current value, program the new value, and press
enter to confirm. (the default value is 3).
VARIOUS PARAMETERS: EVEnT dElAy
indicates the time (in seconds) that the system must wait before it sends a signal following a first event notification: i.e. [value 10
seconds] with opening and closing of input 1, the signal will be immediately sent out. to re-open the same input within the pro-
grammed10 seconds, the second signal will not leave immediately, but once the 10 seconds have lapsed.
Once you have accessed the menu, press enter to change the value, press CanCel to cancel it.
VARIOUS PARAMETERS: AccEPT cAllS
enable or disable the answer to all incoming calls.
Once you have accessed the menu, press enter, program the value (0=disabled 1=enabled) and confirm by pressing enter.
VARIOUS PARAMETERS: ThRU RIng
either enables or disables a programmed output with ring function: this output simulates the incoming "ring" during the reception of an exter-
nal call. it is used when you want to apply a line simulator also to receive phonecalls.
Once you have accessed the menu, press enter, program the value (0=disabled 1=enabled) and confirm by pressing enter.
EnvironmEnt volumE
it is possible to change the volume of the environmental listening system. (default 8).
Once you have accessed the menu, press enter and program te value, confirm with enter.
note: if the environmental listening is enabled, it is also possible to change the listening volume during a call, by
pressing the keys of your phone using the keys 1 - 2 (1 = raise volume, 2 = lower the volume).
www.amcelettronica.com
Call status:
– the dialler is not able to call (example: not registered to GSM)
– the dialler is calling the number desired
– the number set is ringing
– sending data to receiver
– test finished successfully
– test finished with error
17
VOX-4W v. 1.0