WWDLWx User Manual Date: 19-Apr-2023 1 INTRODUCTION 1.1 What's LoRa LoRa (short for long range) is a spread spectrum modulation technique derived from chirp spread spectrum (CSS) technology. Semtech's LoRa devices and wireless radio frequency technology is a long range, low power wireless platform that has become the de facto technology for Internet of Things (IoT) networks worldwide.
Can be provided by Factory” or requested by SI AppsEUI Can be provided by Factory" or requested by SI Device Type Sensor Class Type Class A API Protocol Provide Provided by Ubitech Firmware Update Yes (OTW with CommBox) Alarm Report Temperature Report Uplink Downlink Congurable...
WWDLWx User Manual Date: 19-Apr-2023 3 WHAT INSIDE IN THE BOX Standard Custos Wireless Water Detector (WWD) package comes with below items 3.1 Custos WWD Main Unit X1 (Figure 3A) 3.2 Remote Water Detection Probe (Optional) X1 (Figure 3B) F i g u r e 3 B Figure 3A Version: 0.2.0...
WWDLWx User Manual Date: 19-Apr-2023 6 ACTION SENSOR & INDICATORS BEHAVIOR 6.1 3-axis Action Sensor Built-in 3-Axis Accelerometer for gesture recognition by detecting a series of movements, Once the 3- Axis Action Sensor is activated, you also can see below Visual and Sound Indicators response with the 3-Axis Action Sensor.
WWDLWx User Manual Date: 19-Apr-2023 7 HOW 3-AXIAL ACTION SENSOR WORKS 7.1 3-axis Action Sensor-Gesture Recognition Procedure -End-user can use built-in 3-axis Accelerometer to replace physical touchable key. it can detect any movement very sensitive, end-user use a series of action to enable some dened function, such as below functions i.To wake up Gustos WWD from sleep mode and send out uplink packet to Gateway / LoRa Server, ii.Factory Default Reset,...
WWDLWx User Manual Date: 19-Apr-2023 8 HOW WATER LEAK SENSOR WORKS 8.1 Water Detection Probes Custos WWD supports two water detection probe: “Build-in” & “Remote” 8.2 Built-in Water Detection Probes Built-in Water Detection Probe WWD has special recess (Figure 8A) which helps induce Water run through it, to create effective detection by probes from both ends.
WWDLWx User Manual Date: 19-Apr-2023 9 WORKING MODE SUPPORT 9.1 Shipping Mode (Deep Sleep Mode) -By default, Custos WWD is set in Shipping Mode to keep it in deep sleep to save power during transport & storage, in this time all functions will be disabled until unlocked it from Shipping Mode. End- user must activate the device from Shipping Mode before joined to any LoRaWAN Network.
WWDLWx User Manual Date: 19-Apr-2023 10 SETUP WITH LORAWAN NETWORK 10.1 Check Network Status -By brand new default, Custos WWD does not belong to any LoRaWAN Network, and it is under shipping mode; -To check Custos WWD Network status, trigger the Built-in Leak Sensor; -Yellow LED ashing means Custos WWD is in Standalone mode, not joined in LoRa network.
WWDLWx User Manual Date: 19-Apr-2023 10.2.2 Activate OTAA &Exits Shipping Mode Permanently (Not Recommended) -OTAA will be activated forever until it joined into a LoRaWAN Network, and it will not return to shipping mode anymore, i.Trigger Built-in Water Leak Sensor for 5 seconds and comes with Yellow LED Lights on per seconds.
WWDLWx User Manual Date: 19-Apr-2023 10.4 Factory Default Reset - To remove all Custos WWD settings without involve LoRa Gateway or LoRa Server. i.Pick up the Custos WWD; ii.Shaking it as picture below (10A), you will get “beep” sound and Green LED blinking, iii.Lay WWD at and wait for 2 sec, then You'll get 2 Buzzer Sounds with Green LED Lights 2 times.
WWDLWx User Manual Date: 19-Apr-2023 11 BATTERY LEVEL 11.1 Battery Level Report -The Battery Level Report will be sent through Uplink packet when triggered 3-Axis Action Sensor or Water Leak Sensor 11.2 Low Battery Alarm -Low Battery Alarm UI will be enabled when battery level less than 15% once triggered the 3D-Axis Action Sensor (Red LED ashing 2 time and buzzer sounds 2 times.) Version: 0.2.0...
WWDLWx User Manual Date: 19-Apr-2023 12 WATER LEAK DETECTION & ALARM 12.1 Water Leak Detection & Alarm -Once the Water Leak Sensor Probe is triggered, the Custos WWD sends Uplink packet with Water Leak Detected to LoRa Server automatically. Version: 0.2.0...
Page 19
WWDLWx User Manual Date: 19-Apr-2023 Contact us if you have any questions https://www.ubitech.com info@ubitech.hk Version: 0.2.0...
Need help?
Do you have a question about the WWDLW Series and is the answer not in the manual?
Questions and answers