MSI MICRO ATX ZX14 Manual page 80

Chassis Intrusion Detect
Set this option to Enabled, Reset, or Disabled the chassis intrusion
detector. During Enabled, any intrusion on the system chassis will be
recorded. The next time you turn on the system, it will show a warning
message. To be able to clear those warning, choose Reset. After clearing
the message, it will go back to Enabled.
CPU Speed
Check your processor and set this function accordingly. If you set
this to Manual, you can set the CPU Ratio and CPU Frequency accordingly.
CPU Frequencies are: 66, 68, 75, 83 and 100, 103, 112. Though 68, 75, 83,
103, and 112 frequencies are available, it is advised that you use these only
for testing since this might cause unstability as the CPU is not designed
for these frequencies. CPU ratio are: 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, or 8.
Note: If you set the CPU Ratio and CPU Frequency to be too high, and the
system will not turn on, restart the system. Press "F10" until bootup. This
will set the default setting.
Chassis/Power/CPU Fan RPM
During Enabled, this will monitor the RPM of your CPU/Chassis/
Power fan.
System Temperature/CPU Temperature
This will show the System and CPU temperature.
CPU Critical Temp
This option is for setting the critical temperature level for the proces-
sor. When the processor reach the temperature you set, this will reduce the
load on the processor.
Shutdown Temp
This option is for setting the Shutdown temperature level for the
processor. When the processor reach the temperature you set, this will
shutdown the system. This function only works with Windows
ing system.
3-29
®
®
95 operat-